Machine &Module:NEJE Max 4 & E80

Material & Tools:3mm plywood, Red spray,transparent sulfate paper
The Idea You Can Get from this Post:

Tutorial Guide:
1.Pre-focus
Place the plywood and measure the focal length between the plywood and the E80 module to be 25mm.
2.Upload Your File
Connect the machine and open lightburn, upload the dxf file you downloaded to the lightburn application interface.

3.The Settings in Lightburn
Cutting: 400 mm/min, 100%power, 1 pass

I am truly thankful to the owner of this website who has shared this wonderful piece of writing at here.
Thank you for sharing indeed great looking !
The information shared is of top quality which has to get appreciated at all levels. Well done…
Thank you for sharing indeed great looking !
A great post without any doubt.