NEJE laser engraver ideas——doorplate

Share Link

Machine &ModuleNEJE Max 4 & E80

Material & Tools:8mm plywood, 2mm cherry wood, 3mm walnut

The Idea You Can Get from this Post:

tutorial Guide


Place the wood and measure the focal length between the wood and the E80 module to be 25mm.

2.Upload Your File

Connect the machine and open lightburn, upload the dxf file you downloaded to the lightburn application interface.

3.The Settings in Lightburn

Cutting:400 mm/min, 100%power, 1 pass

4.Use 8mm plywood as the base, put the cut cherry wood on it, and finally fit the cut walnut parts into the cherry wood.

Share Link

Leave a Comment

Your email address will not be published. Required fields are marked *

Translate »