NEJE laser engraver ideas—Joker DC comic engraving

Machine &Module：NEJE 3 Max v2 & E80

Material & Tools：3mm plywood, ink paint, roller

The Idea You Get From This Post:

1.Pre-focus

Place the plywood and measure the focal length between the plywood and the E80  module to be 25mm.

2.Upload the file

Connect the machine and open lightburn, upload the dxf file you downloaded to the lightburn application interface.

3.The Settings in Lightburn

5000mm/min, 100%power, 2% Overscanning, 254dpi，Jarvis

4. Other instructions

• After the engraving is complete, it can be painted over using ink paint and roller. (right)
• Once it’s evenly applied, you can print the image directly on anything you want. All in all, this is using a laser machine to make a large seal.(left)

5.Note

If your image is just simple black and white, you can trace your image to fill with the settings: 5000mm/min, 90%power. If your image is like this one from DC comic, it has some hard-to-trace lines and shading, please refer to step 4

• NEJE laser engraver ideas——Zodiac Tailsman
• NEJE laser engraver ideas——Teapot storage
• NEJE laser engraver ideas——Mario refrigerator magnet
• NEJE laser engraver ideas——Inside Out 2 Blind Box
• NEJE laser engraver ideas——Easter egg holder