Machine &Module：NEJE Max 4 & E80
Material & Tools：3mm plywood, different colorspray or pen, rope
Method：After cutting, you can paint it according to your preference, and then pass the rope into the hole above.
The Idea You Can Get from this Post:
Tutorial Guide：
1.Pre-focus
Place the plywood and measure the focal length between the plywood and the E80 module to be 25mm.
2.Upload Your File
Connect the machine and open lightburn, upload the dxf file you downloaded to the lightburn application interface.
3.The Settings in Lightburn
Engraving:15000 mm/min, 50%power, 1 passes(right)
Cutting: 500 mm/min, 100%power, 1 passes(left)
- NEJE laser engraver ideas——Zodiac Tailsman
- NEJE laser engraver ideas——Teapot storage
- NEJE laser engraver ideas——Mario refrigerator magnet
- NEJE laser engraver ideas——Inside Out 2 Blind Box
- NEJE laser engraver ideas——Easter egg holder