Machine&Module: NEJE 3 MAX V2&E40
Material: Leaves after vacuum drying (can be stored longer)
The Idea You Can Get from this Post:
①Prepare a clear image, preferably a picture where the shadow can be seen.
②Use ps or other software to invert the picture.(if you plan to put it on a colored background plate, then you can directly engrave the picture. But if you plan to put it on a transparent and colorless background plate, or put it under outdoor light, you need to invert it on PS.)
③Connect the machine and open lightburn, upload the inverted image to the lightburn.
Setting: 6000mm/min, 48%, 254dpi
④Finally, according to the size of your leaf, set the frame range and start making.
Attention: There may be an unpleasant smell when engraving, please choose to engrave outdoors or in a closed box.
- NEJE laser engraver ideas——Zodiac Tailsman
- NEJE laser engraver ideas——Teapot storage
- NEJE laser engraver ideas——Mario refrigerator magnet
- NEJE laser engraver ideas——Inside Out 2 Blind Box
- NEJE laser engraver ideas——Easter egg holder
I want to engrave leaves with a Neje 04640 laser. When I tried to engrave by constantly changing the parameters, I could not perform any operations with the data on your site. Can you help me with this issue?
Make sure the leaves you prepared is vacuum dried and try the speed 6000mm/min, 40%power.
What should I pay attention to when it comes to image or photo recordings? And the leaf is burning and so I want the leaf to stay in the veins on the side. Which mode and which dpi should I work with for this?
As shown in the post, it is a black and white image. I suggest you should try the E40 or A40640 to achieve this. Jarvis and 254dpi wil be fine.