NEJE laser engraver ideas—Totem relief

Share Link

Machine&Module: NEJE 4 MAX &E80

Material&Tools: 3mm Plywood

The Idea You Can Get from this Post:

neje-laser-engraver-ideas

Tutorial Guide:

①Place the Plywood and measure the focal length between the plywood and the E80 module to be 25mm.

②Upload the dxf file in the compressed package below and set the size according to the size of your plywood.

③Setting parameters:Fill mode:12000mm/min,100%power, 1 pass

Cutting: 550mm/min, 100%power,1 pass

④To prevent errors, please engrave first and then cut. Assemble according to pdf tutorial.

neje-laser-engraver-ideas
neje-laser-engraver-ideas

Share Link

Leave a Comment

Your email address will not be published. Required fields are marked *

Translate »