Machine&Module: NEJE Max 4 & E80
Material&Tools:Ceramic plate,Titanium dioxide powder and alcohol (or paint containing titanium dioxide)
Method:Norton White Tile Method
The Idea You Can Get from this Post:
![](https://nejetool.com/wp-content/uploads/2023/11/A21A9763-1024x1024.jpg)
Tutorial Guide
1. Material pre-processing
- Fill a spray bottle with titanium dioxide and alcohol in a 1:1 ratio and shake well.If your paint contains titanium dioxide, then you can just use white spray paint instead of the titanium dioxide and alcohol mixture.
- Spray the shaken mixture onto the plate, one layer drying and then another.Wait for drying.
2. Material test
- Because the actual engraving effect is affected by the module, material, picture and other factors, before the formal engraving, you can additionally prepare the same material to do the test.
- If you use NEJE Max 4 E80, then you can refer to the following test parameters.
3. Lightburn setting
- Place the plate on the honeycomb board and measure the height of the bottom of the plate and the module. This engraving measurement is 35mm.
- Open Lightburn and import the file. Based on the 2 diameters of the plate, draw concentric circles to help locate the pattern position, if your laser engraver has installed a camera , you can combine it with the camera to pinpoint the position.
![](https://nejetool.com/wp-content/uploads/2023/11/Snipaste_2023-11-23_14-50-15-2.png)
![](https://nejetool.com/wp-content/uploads/2023/11/Snipaste_2023-11-23_14-50-35-1.png)
- It is recommended to combine with the motorized z-axis to precisely control the focus. Measure the diameter of the bottom center of the plate and the diameter of the rim, as well as the distance between the bottom of the plate and the middle of the rim.
- Set the parameters. Speed 2000mm/min, power 95%, air assist off. Give the middle position and edge position set different color layers, the middle set z-axis offset 10mm, the edge part of the set z-axis offset 5mm. specific data according to the actual measurement adjustment, the principle is the motorized z-axis down to reach the optimal focal length of 25mm.
![](https://nejetool.com/wp-content/uploads/2023/11/Snipaste_2023-11-23_14-52-19.png)
![](https://nejetool.com/wp-content/uploads/2023/11/Snipaste_2023-11-23_14-51-30.png)
4. Clean the Plate
Wash the plate with water after engraving.
5. Final result
![](https://nejetool.com/wp-content/uploads/2023/11/lQDPJx512wPzvLfNC7jND6CwnWGdNrVgGCkFSJhFeAYoAA_4000_3000-1-1024x768.jpg)
How do you feel about the website? Do you have any suggestion? Please leave your comments.
- NEJE laser engraver ideas——Zodiac Tailsman
- NEJE laser engraver ideas——Teapot storage
- NEJE laser engraver ideas——Mario refrigerator magnet
- NEJE laser engraver ideas——Inside Out 2 Blind Box
- NEJE laser engraver ideas——Easter egg holder
We are a group of volunteers and opening a new scheme in our community.
Your site provided us with valuable information to work on.
You’ve done a formidable job and our whole group will likely be thankful to
you.
Thank you very much for your recognition, you can also share the link to those who need it, thank you for your support, we will keep updating.