Machine &Module：NEJE Max 4 & E80
Material & Tools：3mm plywood, Acrylic paint
The Idea You Can Get from this Post:
utorial Guide：
1.Pre-focus
Place the plywood and measure the focal length between the plywood and the E80 module to be 25mm.
2.Upload Your File
Connect the machine and open lightburn, upload the dxf file you downloaded to the lightburn application interface.
3.The Settings in Lightburn
Cutting:400 mm/min, 100%power, 1 pass engraver：18000 mm/min, 70%power
- NEJE laser engraver ideas——Zodiac Tailsman
- NEJE laser engraver ideas——Teapot storage
- NEJE laser engraver ideas——Mario refrigerator magnet
- NEJE laser engraver ideas——Inside Out 2 Blind Box
- NEJE laser engraver ideas——Easter egg holder
Fantastic site Lots of helpful information here I am sending it to some friends ans additionally sharing in delicious And of course thanks for your effort
Thanks I have recently been looking for info about this subject for a while and yours is the greatest I have discovered so far However what in regards to the bottom line Are you certain in regards to the supply