Glass Carved Santa Claus

Share Link

Machine&ModuleNEJE 3 MAX &E40

Material:plywood, Glass, marker

Tutorial Guide:

  1. Prepare the round glass, plywood, markers, glue
  2. Find your favorite Santa Claus image
  3. Draw the first circle 2mm smaller than the round glass on the side of the imported picture in lightburn, and then make a circle 2mm larger than the round glass to form a frame, and cut two groups
  4. Use a marker to paint one side of the glass with black
  5. Start carving the glass Cutting Power 100% Speed 300/min 1 pass Engraving Power 100% Speed 6000/min
  6. Cut the Border
  7. Wipe off the black marker marks on the glass
  8. Glue the glass between the two borders
Cutting Power 100% Speed 300/min 1 pass Engraving Power 100% Speed 6000/min;Two borders need to be cut
Paint one side of the glass black with a marker, so as to carve a clear image
Glue the glass between the two borders

video display

Relate post


Share Link

Leave a Comment

Your email address will not be published. Required fields are marked *

Translate »