NOTE: It is heavier, not suitable for engraving, only suitable for cutting!
Main applications: cutting, drawing etc.
Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
Radiator size: 30*80mm
Material: copper + aluminum
Drive position: built-in
Is the power adjustable: PWM can be adjusted, PWM: 50KHz-20KHz / 3.3V-12V
Drive protection: surge protection, overvoltage protection
Input power: approx. 12V2A, about20W (without fan power)
Output optical power: 5.5W
Line length: 300mm
Control line installation method: pluggable
Fan size: 30*10mm
Fan speed: 15000 rpm
Controllable temperature: less than 60 degrees Celsius
Best focus range: 40mm-50mm
Max cutting thickness: 10mm (Recommended focus position: 45mm from the light exit
Safety Warning: Please apply this module under the premise of safety protection!
Recommended application machine: NEJE Master
Note: NEJE Master comes standard with 12V2A charger. If you want to upgrade your
old machine, you need to prepare another 12V3A power supply.
1 x module
2 x screw
2 x gasket
1 x control line